我将模型网格细化后重新计算结果,出现无法正常显示 Velocity

SANYAN68

正常显示 Velocity 的状态




我将模型网格细化后重新计算结果,出现无法正常显示 Velocity



网格细化后FLUENT出现下列讯息,但不清楚要如何进行?

** Following expected zones were not found in the current mesh:
**  wall-25-shadow
**  wall-27
**  wall-26
**  wall-9-shadow
**  wall-9
**  wall-huanreguan
**  interfaceshellsolidside
**  interfacetubesolidside
**  interfaceshellfluidside
**  interfacetubefluidside
** Found Following new zones in the current mesh:
**  interfacetubefluidside-contact_region_2-trg
**  interfacetubesolidside-contact_region_2-src
**  interfaceshellfluidside-contact_region-trg
**  interfaceshellsolidside-contact_region-src
**  wall-21
**  wall-24
**  wall-8
**  wall-8-shadow
**  wall-23-shadow
**
** Please ensure that your current Setup is valid.
************************************************************************
************************************************************************
"Model Information is incompatible with incoming mesh.
Found some missing and new zones in the mesh. To make mesh compatible with settings, please visit "Match Zone Names" panel
(Mesh->Recorded Mesh Operations->Edit Incoming Zones... -> Match Zone Names...)."



请神大帮忙! 附上档案...

网格细化前(BEFORE)
网格细化后(AFTER)