grid check出现问题

nickchen0625

我用的是将msh复制到case的方法，但是替换完msh文件，我每次check就出现问题，
Checking element type consistency.
   Zone 3 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
   Zone 4 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
   Zone 5 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
   Zone 6 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
   Zone 7 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
   Zone 9 has 2D faces;
use (%reset-thread-element-type) to change from mixed to 2D
Checking boundary types:
Checking face pairs.
Checking periodic boundaries.
Checking node count.
Checking nosolve cell count.
Checking nosolve face count.
Checking face children.
Checking cell children.
Checking storage.
Done.

WARNING: Grid check failed.
我以前也复制过类似的msh，没有出现这样的情况啊，这次怎么这样了，求指教啊。。。。
在reread-grid时显示
> (reread-grid "houbu2.msh")

Reading "houbu2.msh"...
    6497 nodes.
     508 mixed wall faces, zone  3.
     369 mixed axis faces, zone  4.
      17 mixed pressure-outlet faces, zone  5.
       8 mixed pressure-inlet faces, zone  6.
      10 mixed pressure-inlet faces, zone  7.
   11624 mixed interior faces, zone  9.
    6040 quadrilateral cells, zone  2.
Building grid connectivity...
Done.
()是因为这里的mixed的问题？    我看了一下好像是这个问题，别的网格是2d的，这个2d和mixed的怎么改的啊，我明明用以前的journal文件在gambit里画的怎么成了mixed了呢，请问怎么改啊

[ 本帖最后由 nickchen0625 于 2012-7-15 22:35 编辑 ]